Hoover Plus Manuel d'utilisateur télécharger pdf (Page 9)

Continued ➜

Your HOOVER SteamVac deep cleaner

may also be used to pick up small liq-

uid spills (1 gallon or less, never to

exceed 1/4 inch in depth) on carpet,

upholstery, or bare floors.

For best results, pick up spills immedi-

ately by placing the stair/upholstery noz-

zle just above the spill and suction up

any residue on top of the carpet. If the

spill remains, place either the stair/

upholstery nozzle or floor nozzle with

brushes turned OFF in front of the spill,

pull the nozzle very slowly over the spill

initially with suction only. Repeat with spray

and suction.

When picking up spills on bare floors,

use only the floor nozzle with the bare

floor attachment in place and speed

selector in the OFF position (this will help

p r event spreading the spill).

If a spot is left, the stair/upholstery nozzle is

generally more effective for removing it.

Although no cleaning solution can com-

pletely remove all spots, they can be tre a t -

ed by following the instructions provided by

the manufacturer of the carpet, upholstery,

or bare floor surface being cleaned.

Do not use the SteamVac deep cleaner

to pick up flammable or combustible liq-

uids or chemicals.

When finished, follow “After cleaning”

i n s t r uctions on page 8.

3. Dry hands and plug cord into a prop-

erly grounded outlet.

Do not clean over floor electrical out-

lets.

4. To avoid walking on damp carpet,

start at the end of the room farthest from

the door or path to sink where tanks will

be emptied and filled .

Step on handle release pedal and lower

handle to operating position; turn deep

cleaner ON.

5. Squeeze trigger to release cleaning

solution and slowly push deep cleaner

forward (equals one wet stroke).

6. Continue to squeeze trigger and

slowly pull deep cleaner back toward

To clean the outside of the machine,

wipe off dirt with a cloth dampened in

warm water and mild detergent. Do not

use solvent or petroleum based prod-

ucts to clean the machine.

Carpet Cleaning

Picking up spills

Using the tools

3-2

Read “Before you begin cleaning”

instructions on page 8.

1. Fill clean solution tank (upper tank)

with HOOVER Carpet/Upholstery

Detergent according to instructions on

page 7.

2. Move speed selector to LO for gen-

tle cleaning or Hl for normal cleaning.

you (second wet stroke). Release trigger

and slowly push deep cleaner forward

over area just sprayed with solution (dry

stroke). Then slowly pull deep cleaner

back toward you without squeezing trig-

ger (dry stroke).

7. Overlap strokes by 1 inch to help pre-

vent streaking.

Keep nozzle flat on floor for both forward

and reverse strokes.

For heavily soiled areas, repeat steps 5-

8. To avoid saturating carpet, do not

use more than 4 wet strokes over one

area. Always end with dry strokes.

It is best to alternate wet and dry

strokes as described above.

For best cleaning results and to aid in

faster drying of carpet, end with more

dry strokes. (Continue using dry strokes

until little water is visible passing

through the recovery tank lid.)

Empty recovery tank when the motor

sound becomes higher pitched and

there is a loss in suction (see “Automatic

shut-off”, Fig. 2-6).

When finished cleaning, follow “After

cleaning” instructions on page 8.

The stair/upholstery nozzle has a built-

in brush to help provide the scrubbing

action some spots may need for

removal.

The utility nozzle (some models) can

be used for carpet and upholstery in

vehicles.

How to attach tool

Disconnect deep cleaner from electri-

cal outlet.

1. Place handle in upright position and

remove hose from rack.

All tools attach to the hose in the same

manner:

2. Connect tool to hose by sliding it onto

connector until the tab (C) locks it

securely.

Using your thumb, push forward and

up on the latch (D) to remove tool as

shown.

Read “Before you begin cleaning”

Instructions on page 8.

1. Place handle in upright position.

Agitator brushes will not rotate while

handle Is in upright position.

2. Fill clean solution tank with HOOVER

Carpet/Upholstery Detergent according

to instructions for Figs. 2-10 to 2-16.

3. Attach tool to end of hose.

4. Hose length may require that

machine be placed at the top of the

stairs to clean upper half of stairway

and at bottom of stairs to clean lower

half.

To prevent machine from falling, use

extra caution when cleaning on stairs.

Do not place deep cleaner on stairs.

Do not point tools toward people or

pets.

5. Dry hands and plug deep cleaner

into a properly grounded outlet.

6. Turn deep cleaner ON.

Cleaning carpeted

stairs

3-4

To clean nozzle

If lint or other debris becomes lodged in

nozzle, do not attempt to remove

nozzle cover.

Pour one to two cups of clear water on a

non-carpeted floor. Do not pour water

onto a wood floor.

Pick up water with your ‘SteamVac’ deep

cleaner. Repeat as necessary until

debris is flushed out of nozzle.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Hoover Plus Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Aspirateurs Hoover Plus