Hoover Plus Manuel d'utilisateur télécharger pdf (Page 4)

Press cord into cord clip on back of

handle. Pull cord tight.

4

The assembled cleaner will look like this

drawing (Plus model shown).

1-2

Attach upper handle

Remove clean solution tank (upper tank)

from deep cleaner.

With cord hook (A) to back of deep cleaner,

push upper handle down onto lower han-

dle. Push b o l t s into holes on front of han-

dle. If bolts will not go through hole easi-

ly handle is not pushed completely

d o w n .

1-3

1-6

1-7

Attach hose holder

Position hose holder (B) onto handle by

matching tabs on rack with openings on

back of handle. Make sure holes for

bolts are aligned.

1-8

1 - 9

Place nuts in recessed areas on back

of the hose holder. Hold each nut in

place while tightening each bolt securely

(from the front of the handle) with a

Phillips screwdriver.

Only two nuts are needed on this model.

The extra nut is not required but has

been provided for your convenience.

A

C

When handle sections are completely

together, squeeze trigger (C) on upper

handle to snap trigger rod In place.

Replace clean solution tank (upper tank)

by positioning bottom first. Press on

tank handle to snap top of tank into

place.

Attach tool holder

Remove tool and taped screw from

holder.

Insert projections on rack into slots on

back of cleaner.

Assemble handle

1-4

B

1-5

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire