Hoover Power Nozzle Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 9
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
.
0
Push plug on power nozzle cord
l
completely into cord receptacle
underneath hand grip.
Always disconnect cleaner from elec-
trical outlet before attaching or
removing power nozzle plug.
.
El
For cleaners with plastic wands,
squeeze tabs on separate cord clip
together while pressing cord into small
slot (E).
Snap one cord clip (F) onto each exten-
sion wand. Adjust cord,
placing
excess between nozzle and bottom
cord clip.
a
For cleaners with metal wands,
position cord into cord clips (G) on
wands, placing excess cord between
nozzle and bottom cord clip.
Note: On models with wand storage
clip,
the bottom cord clip is on the wand
storage clip.
To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet. Do not change the
plug in any way.
a
After assembling cleaner, plug
cord into electrical outlet. Turn
cleaner on by depressing ON-OFF
pedal (A). To turn cleaner off, depress
pedal again.
q
On models without cord rewind
pedal,
release cord by rotating
cord hook
(6)
inward before
depress-
ing ON-OFF pedal (A).
Power nozzle
The power nozzle adjusts automatically
for cleaning hard surface floors and vari-
ous heights of carpets.
It is not recom-
mended for very irregular surfaces
such as brick, slate, and certain par-
quet floors unless it is unplugged
from the cleaner.
This will stop the agi-
tator from rotating. If desired, a special
wall/floor brush (shown in “Cleaning
tools” section) can be purchased for this
task, if it is not included with your model.
Handle positions
Edge cleaning
q
The handle has two positions when
used with the power nozzle:
upright and operating.
To lower handle to operating position,
place your foot on the power nozzle and
pull handle back.
q
, Brushed edge cleaning is
provid-
ed on both sides of the nozzle to
remove embedded dirt in carpet near
baseboards and furniture. Guide either
side of nozzle parallel to edge of carpet
or furniture.
Vue de la page 3
1 2 3 4 5 6 7 8 9

Commentaires sur ces manuels

Pas de commentaire